Thermal Shock Test Requirements
The Testing Innovations equipment is one of the only approved manufacturers for automotive Thermal Shock (steam jet) testing.
If you are new to thermal shock testing you may find the thermal shock testing overview helpful to get more familiar with the various OEM thermal shock test methods.
Steam Equipment
Steam Generator: Capable of creating consistent steam with adjustable gas/electric burner. Water flow rate of 2.7 +/- 0.1 L/min and steam dynamic pressure at nozzle of 37.9 +/- 1.9 kPa.
Hose: Capable of withstanding high temperature/pressure steam
Wand Nozzle: Inside Diameter 12.5 +/- 0.3 mm and at least 100 mm long, made of non-corrosive material
Supplied by: Testing Innovations, Inc.
25170 John R Road
Madison Heights, MI 48071
(248) 515-5855
Model number: 100-V2
Dynamic Head Fixture (DHF) – Dynamic Head Pressure
As described in Figure 1 – 3. Must be able to measure discharge dynamic head pressure of 37.9 +/- 1.9 kPa. The measurement is 25 mm from the nozzle using a 4.7 mm ID tube.
Supplied by: Testing Innovations, Inc.
25170 John R Road
Madison Heights, MI 48071
(248) 515-5855
Model number: DHF-1
3.2.1.5 Steam Source. A steam generator per the following description, or equivalent, may be used: Model 100 Steam Generator from Testing Innovations. However, earlier generations of the Model 100, in house steam (no longer an alternative due to inability to control flow) and other equivalent steam generators must be calibrated upon each use with an approved dynamic head fixture. Retro-fit kits are not available. It has been shown that older generations cannot reliably produce the required test conditions. Contact Testing Innovations for information.